Page 2 of 2
Re: firmware for Sangoinololu 1.3a
Posted: Tue Aug 18, 2015 8:48 am
by Mark
Sorry, I download the firmware again, you can check if it is what you want.
Re: firmware for Sangoinololu 1.3a
Posted: Thu Aug 20, 2015 8:32 am
by MannyJayBustos
Ok I will need to take the latest version of Marlin and go over each line of code and manually input the values from Marlin 1.0.0 and put them in to Marlin 1.0.2. That is all you needed to say.
Manny
Re: firmware for Sangoinololu 1.3a
Posted: Tue Jan 31, 2017 9:19 pm
by oroszjrobert
Acrylic Geeetech I3 pro B 3D Printer kit
I need some help.
Assembled it correctly but the z axis does not stop after it pushes down the z axis minimum button ( I hope that is how you call that)
I have the same issue in the case of auto-home also same when I set the home setting manually. The motor keep stopping at the end point and is forcing itself but it will not go any further.
I hope you understand my issue.
Thanks in advance