Geeetech

Mine keeps pausing with the original SD card that was supplied with the printer. I have done no firmware updates and slice with Cura 3.6.0.

Same there. Printer is 3 weeks old. Latest Firmware from official site uploaded - v1.38.59 (it was nightmare to get it working ...). A30 Hardware version 3.40. Slicer - Cura 3.6. Tested probable 10 different SD cards (all works perfectly with mine PrintrBot). Same result - random pause on all prints longer than 3 hours. I'm printing with ABS - "resume" is not an option with this material. I switched off filament run out sensor. This not helped. Any ideas what to try?

P.S. U use "Marlin" style G-Code in Cura. Maybe this is reason? Which style Geeetech suggests to use?

update... With v1.38.59 it pause almost every print now...

You should check the gcode of it at first.
Maybe there are some gcode this printer not support.

Is there any list of supported and not supported G-Codes by A30?

Seriogal wrote: Fri Mar 15, 2019 1:22 am Is there any list of supported and not supported G-Codes by A30?

Pls check it
viewtopic.php?f=92&t=61924

hi all i have the same problem i uploaded the latest software
on each print pause,
I tested the same g codes on tronxy x6a and it works fine.
i use cura and prusa slicer edition in all the same.
my geeetech a30 is the 24v version motherboard gtm 32
please help
the printer has 3 months

Hi, did you use http://geeetech.com/forum/viewtopic.php?f=92&t=61924

Hi
thanks

if anyone can give a specific answer to this problem, I am not told anything by the G-codes.

19.01.2020
00:04
today it was displayed on LCD during printing
pause and then temp_exception