Page 2 of 2
Re: ready to give up!!!!!!
Posted: Thu Nov 15, 2018 4:12 pm
by ebam2014
davepmer wrote: Thu Nov 15, 2018 8:10 am
Yeah baby step z , in the config.h file you use to compile the firmware
oh now thats cool... so how would we actually do that??? what do we need to do??
Re: ready to give up!!!!!!
Posted: Thu Nov 15, 2018 8:32 pm
by davepmer
Also, check the temperature, I found out why my white would not stick. It must be labeled wrong, it is labeled 215 to 230 but I accidentally started printing at 190, I turned it up but noticed my white sticking to the bed at 200 and sticking really well at 210. Above 213 it stopped sticking
Re: ready to give up!!!!!!
Posted: Fri Nov 16, 2018 10:03 am
by davepmer
Baby stepping is in the configure_adv.h file
Re: ready to give up!!!!!!
Posted: Fri Nov 16, 2018 2:27 pm
by ebam2014
davepmer wrote: Fri Nov 16, 2018 10:03 am
Baby stepping is in the configure_adv.h file
so how would I edit it? what do I actually need to do? can this be done to the STOCK firmware?
Re: ready to give up!!!!!!
Posted: Sun Nov 18, 2018 9:28 am
by Ken234
I've finally got it working but it took a bit of research and a lot of questions.I didn't realize that the g code tells the printer to do the bed leveling I have a prusa mk2.5 and it just did it whenever I printed so I though it was in firmware,now my problem it my start g code I can't get it to use the temps in the slicer and also one extruder stops pushing filament