Page 2 of 2
Re: Printing High Problem
Posted: Mon Oct 29, 2018 2:07 am
by _kaktus_
Ok, you finally have a different model.
In this case, check the setting of your model in Slicer.
That it is not raised above the surface. Or, that it is not located below the surface.
Re: Printing High Problem
Posted: Mon Oct 29, 2018 2:27 am
by jogi
I use Cura and Slice3r , an there is no option to change the startpoint high.
Re: Printing High Problem
Posted: Mon Oct 29, 2018 2:44 am
by _kaktus_
You have temporarily exhausted my pool of ideas.
Try to think carefully about what we were talking about.
