Re: First 5-10mm in Height are fine, then only thin layers
Posted: Tue Dec 04, 2018 11:48 pm
Hi.
When analyzing the temp-tower, pay attention to where the filament is sufficiently connected and where no melting can be seen.
Your photos are nice but not suitable for analysis. They came out a little bit poorly.
For me, the black bridge with a description of 200 looks the most beautiful. But I can't see the details of the printout.
Unfortunately, nothing can be seen on the orange tower.
William's hints seem to be very valuable.
When analyzing the temp-tower, pay attention to where the filament is sufficiently connected and where no melting can be seen.
Your photos are nice but not suitable for analysis. They came out a little bit poorly.
For me, the black bridge with a description of 200 looks the most beautiful. But I can't see the details of the printout.
Unfortunately, nothing can be seen on the orange tower.
William's hints seem to be very valuable.