Page 2 of 2
Re: Layers finish with gaps...
Posted: Mon Nov 25, 2019 4:07 pm
by motcher41
William wrote: Mon Nov 25, 2019 3:58 pm
Hi, If you print the print model on the picture,
There is no need to turn on the reaction.
And you need level the bed,refer the speed:30-60mm/s.
you think retraction could cause that?
Re: Layers finish with gaps...
Posted: Tue Nov 26, 2019 3:04 pm
by AQUASUN
I had the same Problem with a new Nozzle 0,4mm,
instead 45-001-0114 , i took 45-005-0114 (MK8)
I adjust the amount of the filament from 100 to 250.
OK
Re: Layers finish with gaps...
Posted: Fri Nov 29, 2019 11:40 pm
by Jarda3d
Did you know, what you are doing? If you will continue with similar changes, your printer should be fall to state, from which you did not bring it alive again.
Please read my topic about A10 profile, below.