A20T and 3DTouch firmware

[Yaroslav]

hi Vert.
I figuratively put it about the "big problem" comparable to an elephant. I don’t, you don’t eat an elephant at a time, so I offered to eat piece by piece.

1.you have an a20t printer. right?
2. with or without tach?
3.did you easily replace Marlin Marlin 1.1.8 with more recent Marlin 2.?

Thank you
Yaroslav

[Yaroslav]

Hi vert
if put a 3dtouch on the printer, then it will not work now on marlin 2.0, right?

[Yaroslav]

hi Vert.
and what is the test? what do you need?
another experimental printer or what?
If this printer does not kill, am I ready to try under your leadership?
Well, if of course it is possible

[Yaroslav]

Vert

I'm interested in this because I want to get a full-featured printer + learn something new, stretch the brain a little.
and the second reason, since my daughter draws in my subjective opinion is not bad, I want to transfer some drawings to 3D and, as they say, feel with my hands.

[Yaroslav]

hi vert
clear,
Something came to Paypal Donation: https://www.paypal.me/vertabreaker,
otherwise I have doubts

[Yaroslav]

why I asked a question: because it just showed up a slightly different name and it confused me

[Yaroslav]

question, marlin 2.0 is installed on the same hardware as 1.8?

[Yaroslav]

yes 1.1.8

[Yaroslav]

ok

[Yaroslav]

Hi Vert.
excellent!!! I will try to see today !!

Thank you
Yaroslav