Page 3 of 3
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Thu Dec 03, 2015 6:03 pm
by divtec
I am having the same problem when trying to us both extruders.
Is the firmware fixed yet. I just downloaded and uploaded the November Firmware... but, dual extruder problem is still there.
When can we expect a fix?
FYI: I purchased my G2s back in July 2015, I really like it. Took a bit to get it to work correctly... but, it does perform very well.
Thanks is advance...
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Fri Dec 04, 2015 2:58 pm
by Mark
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Fri Dec 04, 2015 4:18 pm
by divtec
Yes this is the Firmware I compiled and uploaded to my G2s... the problem is still there.
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Fri Dec 04, 2015 4:39 pm
by Mark
which one did you download? and your printer is G2S or G2S pro? I'll test it with my G2S pro.
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Sun Dec 06, 2015 5:47 pm
by divtec
I downloaded G2s for the plastic G2s machine... NOT the firmware for the metal version G2s.
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Mon Dec 07, 2015 6:11 pm
by Mark
Sorry the version for the plastic one is the wrong one, but the metal one is the correct one, now we have updated it, please check it agian, tks!
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Tue Dec 08, 2015 4:19 pm
by divtec
Ok... to clarify... you said that you "updated" it.
Does that mean that I should use the one for the plastic machine again... since it's been updated...
or should I download the one for the metal machine and use it?
Please be specific.
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Tue Dec 08, 2015 4:49 pm
by Mark
yes choose the one for your plastic G2S, I have replaced the old firmware with the new version.
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Tue Mar 01, 2016 3:22 am
by thebatfink
Hi. Today I also have started to see this behaviour after some time of no issues printing.
I have metal G2S Pro and currently only using extruder 1 (2 is not in use).
When hitting manual extrude in repetier all 3 axis begin to move up and no extrusion occurs. I have re-downloaded the firmware and see no difference, all axis still move when trying to extrude??
Re: Delta Rostock mini G2s Extruder drives Axial motors
Posted: Tue Mar 01, 2016 9:19 pm
by Mark
did you home the printer before move the extruder? if not then it will behave like this.