Page 4 of 4
Re: M201 - won't print
Posted: Wed Aug 24, 2016 6:16 pm
by Ariel
Today I print nicely, I just push a little the wire during the first layer and watch for buildup of drops on the bottom.
Otherwise it all works for me.
Re: M201 - won't print
Posted: Wed Aug 24, 2016 7:27 pm
by idom
Ariel wrote:You can cut a small piece of tube and stick it inside, as I did.
So you don't have to worry about insertion length.
I did so, but the tech support suggested direct insertion. Anyhow, it is not nice to be clueless during the building and this affects all new users.