Page 4 of 5
Re: Z home with autolevel
Posted: Tue Jul 19, 2016 10:03 am
by qdshombre
1
if I change Y with Z , I cannot test Z because I have to test X and Y before and Y cannot work , the Y motor dont stop. so I cannot test Z because I have to unplug .
2
no problem of welding because the contact functioned with the switch before the sensor
Re: Z home with autolevel
Posted: Tue Jul 19, 2016 12:02 pm
by William
qdshombre wrote:1
if I change Y with Z , I cannot test Z because I have to test X and Y before and Y cannot work , the Y motor dont stop. so I cannot test Z because I have to unplug .
2
no problem of welding because the contact functioned with the switch before the sensor
OK,what kind of sensor are you using?Attach a pic if possible.
Re: Z home with autolevel
Posted: Tue Jul 19, 2016 6:42 pm
by qdshombre
how to test otherwise z home?
Re: Z home with autolevel
Posted: Tue Jul 19, 2016 10:29 pm
by qdshombre
here. how to test otherwise z mini?
- capteur.jpg (123.03 KiB) Viewed 12095 times
Re: Z home with autolevel
Posted: Wed Jul 20, 2016 11:49 am
by William
qdshombre wrote:here. how to test otherwise z mini?
capteur.jpg
Hi,
I think you can refer to the two posts,they must be helpful to you:
http://www.geeetech.com/forum/viewtopic ... 18&t=17341
http://www.geeetech.com/forum/viewtopic ... 18&t=17004
Re: Z home with autolevel
Posted: Wed Jul 20, 2016 3:36 pm
by qdshombre
but I have already seen these posts, my circuit proposed page 3 is not good? this is exactly the same idea.
How can I test my Z min?
Re: Z home with autolevel
Posted: Wed Jul 20, 2016 4:56 pm
by Cup
qdshombre wrote:but I have already seen these posts, my circuit proposed page 3 is not good? this is exactly the same idea.
How can I test my Z min?
Hi,
Where you bought the sensor?The seller didn't give you a user manual??And can't you plug the sensor connector into the Z_max port?
Re: Z home with autolevel
Posted: Thu Jul 21, 2016 4:44 am
by qdshombre
Cup wrote:
Hi,
Where you bought the sensor?The seller didn't give you a user manual??
Hi,
The sensor is not a problem, only 3 cables.
Cup wrote:
And can't you plug the sensor connector into the Z_max port?
Maybe if Z min is faulty but I do not know how to test Z min.
Re: Z home with autolevel
Posted: Thu Jul 21, 2016 8:43 am
by Cup
qdshombre wrote:Cup wrote:
And can't you plug the sensor connector into the Z_max port?
Maybe if Z min is faulty but I do not know how to test Z min.
Why did you say that?You said "the contact functioned with the switch before the sensor" before,and it means the Z_min port has no problem,doesn't it?
Re: Z home with autolevel
Posted: Thu Jul 21, 2016 10:50 pm
by qdshombre
Cup wrote:Pourquoi avez - </font><font>vous dit? vous avez dit "le contact a </font><font>fonctionné avec l'interrupteur avant que </font><font>le capteur" avant, et cela signifie que </font><font>le port Z_min n'a pas de </font><font>problème, non?</font></font>
I don't know, it does not work now from the sensor