Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

A10M upgrade to 2 extruder 2 nozzle setup

http://forum.geeetech.com/viewtopic.php?t=62332

Page 5 of 5

Re: A10M upgrade to 2 extruder 2 nozzle setup

Posted: Mon May 04, 2020 10:01 am
by William
the brother wrote: Sun May 03, 2020 9:24 pm hi guys,

I'm new to the forum and I've had a A10M printer for about 3 weeks now and I've done lots of successful prints after i sorted out the initial bugs. However I'm now getting a clogged nozzle regularly :( and now I'm looking to switch to a dual hotend for PLA with PVA supports.

I've ordered the hotend and the other bits and pieces but is there somewhere I can get the firmware that supports the 2 in 2 out hotend?

thanks
Sorry，we do not have A10M 2 in 2 out firmware.
All times are UTC+08:00
Page 5 of 5

Powered by phpBB® Forum Software © phpBB Limited