Geeetech

hello,
I'm trying to connect a HY-TFT280_262K to a sainsmart Mega2560 board using your wiki.
The problem is that the pinout does not compare to the examples in the wiki.

So for example I have DB0 to DB7 and then DB10 to DB17 missing DB8 and DB9
I also have pin LEDK which is missing in the wiki

The Layout is very confusing.
Connectors 1 to 20 are in the wrong direction and Db0 to DB7 are not on 21 to 28

Greetings
Werner

HI friend.
Thanks for your post.
It must be used with shield board.
You couldn't use it on arduino directly.
Any other problem.
Just tell me.
Thanks.

HI my good friend,

If I would have a shield and if it would work, OK.
But I have no shield, so I need a schematic to know how to connect to any microprocessor board other than arduino and so on.

I have other boards with motorola 6809 processor which i created together with a friend.
There will be a shield if I am able to construct one and therefore I need Information about the display.

OK, once more :
16 bit data bus is normally DB0 to DB15
my board is missing DB8 and DB9 but has DB16 and DB17
Where is the problem ?

You see, I need Information and not a shield.
There is another topic in this forum : HY-TFT280 problem by angelo56.
He has the same board, as I see on the photo that he send.
Please compare the pinout on this photo and tell me why the pinout does not compare to any example in the wiki.

Greetings
Werner

Hi friends,

will someone pease reply to my post about 5 days ago ???

Greetings
Werner