Page 1 of 3
Sanguinololu Rev 1.3a Firmware
Posted: Tue Feb 24, 2015 8:05 am
by my900ss
I have the Unassembled-Full Acrylic Quality High Precision Prusa Mendel I3.
Sanguinololu Rev 1.3a
Nozzle 0.3mm
PTFE tube size 1.75mm
I need the firmware(ZIP.files) to upload it to my controller with arduino.
Thanks,
Troy
Re: Sanguinololu Rev 1.3a Firmware
Posted: Tue Feb 24, 2015 11:17 am
by rita
hello troy, please leave your e-mail address
Re: Sanguinololu Rev 1.3a Firmware
Posted: Tue Feb 24, 2015 11:40 am
by my900ss
Ms. Rita,
If you would be so kind as to email it to me I would be grateful.
Troy
Re: Sanguinololu Rev 1.3a Firmware
Posted: Wed Feb 25, 2015 3:59 am
by darraughbj
Ms. Rita,
I am in need of this firmware as well, would you be so kind as to send me a copy?
darraughbj@gmail.com
Bart
Re: Sanguinololu Rev 1.3a Firmware
Posted: Wed Feb 25, 2015 9:39 am
by rita
firmware sended, please check your mail
Re: Sanguinololu Rev 1.3a Firmware
Posted: Wed Feb 25, 2015 10:07 am
by my900ss
Rita,
I do not see an e-mail from you yet?
Re: Sanguinololu Rev 1.3a Firmware
Posted: Wed Feb 25, 2015 11:51 am
by rita
Hello, Troy, please check again
Re: Sanguinololu Rev 1.3a Firmware
Posted: Wed Feb 25, 2015 8:45 pm
by my900ss
Rita,
I received the FW thank you.
Troy
Re: Sanguinololu Rev 1.3a Firmware
Posted: Thu Feb 26, 2015 2:09 am
by darraughbj
Thank you, burned in perfectly.
Re: Sanguinololu Rev 1.3a Firmware
Posted: Thu Feb 26, 2015 4:59 am
by my900ss
Pardon me if I am a little frustrated, but I am unable to load the FW. There are large gaps in your FW procedure, I cannot resolve or even get close to resolving the FW issue on this Sanguinololu board. I will need either clear and concise directions on how to install the FW I was provided or a new board with the FW installed.
Regards,
Troy