Page 1 of 1
firmaware erase
Posted: Wed Feb 25, 2015 8:40 am
by dress
I install marlin firmware, but now my printer not work fine, how i get the original firmware. my printer is
http://www.geeetech.com/acrylic-geeetec ... p-884.html
i have ramps 1.4
Re: firmaware erase
Posted: Sun Mar 22, 2015 10:31 am
by jhoarty
How do I load the firmware to the controllers? I finished building the Prusa i3 Acrylic Pro
http://www.geeetech.com/wiki/index.php/ ... ction(8mm) and when I power it on a green light on the controller board blinks twice and the LCD panel lights up, but there is nothing on the LCD screen (it is blank) and nothing happens at all. Do I need to load the firmware?
Re: firmaware erase
Posted: Mon Mar 23, 2015 9:53 am
by zhangxueyou
Hi,jhoarty
You can refer to this page to see how to upload the firmware:
http://www.geeetech.com/wiki/index.php/ ... nt_setting
Re: firmaware erase
Posted: Mon Mar 23, 2015 6:48 pm
by jhoarty
Thank you. I figured it out yesterday and I am printing now. Thank you!