PTFE Tube for 1.75 and mk8
Posted: Thu Apr 02, 2015 8:53 pm
Hi
My nozzle was clog for Mk8. So I took it apart and clean it.
1.75mm nozzle 0.3mm.
Anyway, a piece of PTFE Tube for 1.75 fell off.
I didn't see where it come from. Do you have a picture of Pteee tube 1.75mm where I should put back into mk8 extruder.
Thank
My nozzle was clog for Mk8. So I took it apart and clean it.
1.75mm nozzle 0.3mm.
Anyway, a piece of PTFE Tube for 1.75 fell off.
I didn't see where it come from. Do you have a picture of Pteee tube 1.75mm where I should put back into mk8 extruder.
Thank