Page 1 of 2
Printer disconnecting
Posted: Thu Apr 09, 2015 12:17 am
by PseudoXenon
I have another problem with my printer, when i tell the printer to heat to a specific temperature it gets to the temperature, then it disconnects.
Does anyone have any ideas?
Re: Printer disconnecting
Posted: Thu Apr 09, 2015 8:54 am
by zhangxueyou
How do you tell the printer to heat, by LCD or Repetier on computer?
Re: Printer disconnecting
Posted: Thu Apr 09, 2015 10:52 am
by PseudoXenon
By using repetier on the computer
Re: Printer disconnecting
Posted: Thu Apr 09, 2015 11:33 am
by zhangxueyou
Which one is heating? Extruder or hotbed?
Re: Printer disconnecting
Posted: Thu Apr 09, 2015 8:07 pm
by PseudoXenon
I am heating the extruder
Re: Printer disconnecting
Posted: Fri Apr 10, 2015 9:32 am
by zhangxueyou
When you are heating the hot bed or heating both hot bed and extruder, what will happen?
Re: Printer disconnecting
Posted: Mon Apr 20, 2015 4:51 pm
by PseudoXenon
I dont use the hot bed, I am only heating the extruder
Re: Printer disconnecting
Posted: Mon Apr 20, 2015 4:57 pm
by zhangxueyou
You can try Repetier Host 1.0.6.
Re: Printer disconnecting
Posted: Mon Apr 20, 2015 5:05 pm
by PseudoXenon
I just updated and tried again and the same thing occurred
Re: Printer disconnecting
Posted: Tue Apr 21, 2015 11:26 am
by zhangxueyou
What is your printer type and mainboard type? Did you change the firmware?