Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Slicing software

http://forum.geeetech.com/viewtopic.php?t=16249

Page 1 of 1

Slicing software

Posted: Tue Apr 14, 2015 10:20 pm
by szeiger
I strongly suggest the new cura slicer software from http://reprap.org/wiki/Cura compared to what is included with Repetior host. Also check out netfabb.com for dividing up a 3d print to fit on the printing bed.

Just passing along, I am not affiliated with either one.

Scott

Re: Slicing software

Posted: Fri Apr 24, 2015 12:26 pm
by orest
What are your settings for the Geeetech Prisa i3 B?
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited