Auto-leveling problem and broken spider
Posted: Tue Jul 07, 2015 10:34 am
Hi,
I have Delta Rostock G2 mini. After proper setup I ran auto-leveling routine using G29 command. It went normally for the first 4 or 5 measuring points, but then Y axis alone started to slowly move down and broke one of spider's mount (see attached picture).
Can I have a replacement? Also I'd like to have a file to print out new spider because I dont want to wait a month for new part.
Thank you.
I have Delta Rostock G2 mini. After proper setup I ran auto-leveling routine using G29 command. It went normally for the first 4 or 5 measuring points, but then Y axis alone started to slowly move down and broke one of spider's mount (see attached picture).
Can I have a replacement? Also I'd like to have a file to print out new spider because I dont want to wait a month for new part.
Thank you.