Page 1 of 1
4 Months Old Hot End On Fire
Posted: Wed Jul 08, 2015 2:44 am
by Khilborn
Our printer is 4 months old and has been running fine. Hot end temp is always at 205 printing PLA. Half way through a print the Hot End started sparking and caught on fire....... 4 Months old? Come on guys, these should last a lot longer. Please honor warranty and send me a new one. I can send pictures upon request.
Re: 4 Months Old Hot End On Fire
Posted: Wed Jul 08, 2015 9:45 am
by Admin
Could you provide more details.Please take some pictures in different angle and post the photos to geeetech forum.
Re: 4 Months Old Hot End On Fire
Posted: Wed Jul 08, 2015 9:52 pm
by Khilborn
Details? Stopped in the middle of printing, sparked and caught fire. Luckily I was in the room to catch it or my house would of burnt down.
Re: 4 Months Old Hot End On Fire
Posted: Mon Jul 13, 2015 3:06 pm
by Sherry
hi,my apology for delay in responding.we can't not fix the printer in technology since the hotbed end have been destroyed.Please contact the salesman.