G-Code will not manually move Delta Rostock G2S
Posted: Fri Jul 10, 2015 11:16 pm
Hi,
I have assembled the 3D Printer & am " Printer Preparing " at step 2 of section 2 to measure the distance between the nozzle & print surface. When I put in the G-Code 'G0 X0 Y50 Z2' there is no movement of the print head after pressing 'Send'. Between 'Manual Control' tab & the "G-Code" line it says there are '6 Command Waiting' before adding 'G0 X0 Y50 Z2'. For your information I had changed both the 'Start G-code' & 'End G-code' as shown in the red boxes for 'Slic3r' earlier.
I have also tried to access the Arduino 'sketch_may22a' but cannot find it. I am using Windows 8.1 & used to have trouble linking my Mega 2560 to the laptop.
Have I missed something? Walter
G-Code will not manually move Delta Rostock G2S
I have assembled the 3D Printer & am " Printer Preparing " at step 2 of section 2 to measure the distance between the nozzle & print surface. When I put in the G-Code 'G0 X0 Y50 Z2' there is no movement of the print head after pressing 'Send'. Between 'Manual Control' tab & the "G-Code" line it says there are '6 Command Waiting' before adding 'G0 X0 Y50 Z2'. For your information I had changed both the 'Start G-code' & 'End G-code' as shown in the red boxes for 'Slic3r' earlier.
I have also tried to access the Arduino 'sketch_may22a' but cannot find it. I am using Windows 8.1 & used to have trouble linking my Mega 2560 to the laptop.
Have I missed something? Walter
G-Code will not manually move Delta Rostock G2S