Page 1 of 1

How to upload firmware for Dual Extruder i3 pro C

Posted: Mon Jul 20, 2015 1:22 pm
by shiva
Hi
I recently brought Geeetech Dual Extruder Prusa i3 pro C kit. I assembled printer.
Still i dint get good print yet.
I am using Repetier-Host 1.5.3 Version.So please let me know,
1) Which firmware i have to download ?
2) How to upload firmware step by step guide?
3) Also please let me know best software setting for Dual Extruder i3 pro C .

Thanks
Shiva

Re: How to upload firmware for Dual Extruder i3 pro C

Posted: Mon Jul 20, 2015 2:03 pm
by Sherry
shiva wrote:Hi
I recently brought Geeetech Dual Extruder Prusa i3 pro C kit. I assembled printer.
Still i dint get good print yet.
I am using Repetier-Host 1.5.3 Version.So please let me know,
1) Which firmware i have to download ?
2) How to upload firmware step by step guide?
3) Also please let me know best software setting for Dual Extruder i3 pro C .

Thanks
Shiva
hi,shiva,the related firmware and guidance have been sent to you email.the firmware is for i3 pro c of which main board is gt2560.please check.

Re: How to upload firmware for Dual Extruder i3 pro C

Posted: Sun Sep 27, 2015 8:29 am
by leoval
HI, I have the same problem!!!

I need the last firmware for the Prusa i3 Pro C Dual Extruder and the instruction for update it.

Please send it to my mail leoval@gmail.com

Thanks a lot and have a nice day!!!

Leo

Re: How to upload firmware for Dual Extruder i3 pro C

Posted: Sun Oct 11, 2015 5:34 pm
by Mark
Hi Leo, download the firmware here:
http://www.geeetech.com/forum/viewtopic ... 10&t=17046

Re: How to upload firmware for Dual Extruder i3 pro C

Posted: Sun Oct 04, 2020 2:05 pm
by Mooj
Hello,

I have tried to upload the firmware update Marlin_GT2560-PI3_Pro_C.zip
but get and error

struct fops_t {

Re: How to upload firmware for Dual Extruder i3 pro C

Posted: Sun Oct 04, 2020 5:48 pm
by Mooj
Found solution, arduino 1.0.1. I was using a later version.