Geeetech

lol figured out way I was not getting any pla out of hot end & why pla is oozing from hot end.... both of my hot ends have no holes for pla to extrude from...lol
was I to drill out holes? ... do I need new hot ends? one has pla oozed out from every seem but not out of end.. due to no hole to extrude from....plzcontact me asap.

Do you have a pic of the hotend?

yes

the picture is too small to see the details...

is this better ? see pla around hot end ... Oozed out from every seem but no pla extruded due to no holes . WTF ?Hot ends need to be replaced? fixed asap been working on this for way too long too may small issues that have kept me from using 3d printer.

I used a magnifying glass & a tiny wire to check for holes & found that they were none. See around extruder "nozzle" pla has oozed from seem . TYPE of hot end has no way to exchange nozzle one piece. Is there a fix? exchange or replacement? I wish to get this working asap. been a long time waiting for this or that. missing part now hot ends without holes to extrude from.... Can I replace the hot end heat block & use a heat block that allows replacement of nozzles? or Am I going to need to replace complete hot ends? Are there better hot ends to replace these with from you, What can & will you do to help me get this working? I am frustrated

can nozzles be replaced or do complete hot ends need to be replaced? see pla oozed from seems not from nozzle due to no hole to extruded from. best pics I was able to send due limits.

You shoul contact the seller to replace them, replace the hotends not just nozzle.

they are taking care of it. good service. I never checked until too late lol.... glad they are helping me I would have had so much extra issues with out their help. so close to 1st print now....