Geeetech

HELLO MY NAME IS mARCO i am french

config sanguinololu 1.3 lcd panololu arduino 10.00 windows 10

I HAVE THIS MESSAGE OF ERROR SOLUTION WOULD YOU



In file included from /Marlin.h:22,
from BlinkM.cpp:5:
Configuration.h:48: error: expected unqualified-id before numeric constant

Have you select the correct board type in your firmware?
If so, this might probably caused by the arduino version, you can try to use another version, but don't use the latest one, it has lots of problems.
here is the link for the arduino1.0.1 I use:
http://www.geeetech.com/wiki/index.php/ ... _Resources
and you can refer to the link here to install the firmware:
http://www.geeetech.com/forum/viewtopic ... 20&t=16433