Geeetech

Hello guys, I have a Geeetech gt2560 and the heated bed is not heating at all. I plugged the heated bed into the extruder hotend power slot and the heated bed works.

Is there any way I can use the second extruder power plug for the heated bed? Or any other way to fix it?

Thank you,

maybe your mosfet for hotbed is dead, you can check this link here first:
http://www.geeetech.com/forum/viewtopic ... 13&t=17039

Thanks Mark, it was the fuse. A big issue to get that fuse over here.

then you can contact the seller to get a new fuse.
the type of the fuse is as follows:
name specific type parameter
heater fuse ， SMT 5*10 ， 0154010.DRT ， 10A/125V
hotbed fuse ， SMT 5*10 ， 0154015.DRT ， 15A/125V