Geeetech

Posted: **Thu Dec 17, 2015 2:52 am**

Hi,

Is there any way to prevent the motors from timing out and the print head dropping on the G2S Pro printer? It gets annoying while trying to calibrate and print when the head suddenly drops to the bed.

Thanks for your help!

Dave

Posted: **Thu Dec 17, 2015 2:48 pm**

uh...you can manually move the Z axis now and then to keep it busy I think.
And maybe set it here:

: 12.jpg (196.31 KiB) Viewed 7438 times

: 11.jpg (287 KiB) Viewed 7438 times

Posted: **Thu Dec 17, 2015 9:21 pm**

Mark,

Thank you very much! Very useful.

Dave

Posted: **Fri Dec 18, 2015 4:54 pm**

I just find out another way, you can check it here:
http://www.geeetech.com/forum/viewtopic ... 519#p28519

Geeetech

G2S Pro Motor timeout / Head dropping

G2S Pro Motor timeout / Head dropping

Re: G2S Pro Motor timeout / Head dropping

Re: G2S Pro Motor timeout / Head dropping

Re: G2S Pro Motor timeout / Head dropping