Page 1 of 1
Print bed
Posted: Wed Jan 13, 2016 3:46 am
by Tod
The extruded filament will not adhere to the print bed. It just gathers around the extruder. can anyone help me with this?
Re: Print bed
Posted: Wed Jan 13, 2016 5:27 pm
by Mark
make sure the distance between the nozzle and bed after homing is proper, usually it is the thickness of a normal paper. And use some glue or tape on the bed, it will be better.
Re: Print bed
Posted: Sat Jan 23, 2016 12:19 pm
by braza
I have some problem with the bed , it is no flat enough, is more concave both the hot bed and the aluminium plate. that is mean even if I calibrate the four corner at the same distance from the extruder, in the center the distance is bigger .
Can someone help me with this?
Re: Print bed
Posted: Sat Jan 23, 2016 2:39 pm
by Mark
Clamp a glass on the bed so it will be flat enough.
Re: Print bed
Posted: Fri Jan 29, 2016 7:59 pm
by Tarek Rene
I had the same problem with ABS curling arround the extruded after hours of trial and error I was able to solve the problem by reducing the speed to 67 and I made sure that my bed temp 110 and extruded temp at 260 for the first 2 layers and it worked for me after almost 8 hours of hard trying
Note I'm using PET tape glued on the aluminum bed
Re: Print bed
Posted: Mon Mar 28, 2016 10:23 pm
by pjpsoft
I have the same problem with my G2S
The bed default temp is 55 and you push it up to 110?
What is PET tape?
My head goes down to 1 sheet of paper sliding with effort when at 0. How do you calibrate it : free, tight, unmovable?
Is it really important that M114 shows 0? My best result was -0.09
Thanks for your help