Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Replacing Makerbot Rep 2x Extruders with Geeetech dual ext

http://forum.geeetech.com/viewtopic.php?t=17543

Page 1 of 1

Replacing Makerbot Rep 2x Extruders with Geeetech dual ext

Posted: Sun Feb 28, 2016 9:37 am
by Mauzman
I purchased the Geeetech Dual MK8 extruder assembly. I wanted to replace my OEM extruder that came with the Makerbot 2x. I wired everything up and matched the hookups. Fired it up and kept getting a temperature error, I could not get the Geeetech extruders to heat up, constant errors. I then wired up the OEM extruders and they worked perfectly. I worked on troubleshooting for 4 hours and feel like I am banging my head against the wall. Please help or let me know if you have figured out how to upgrade to these performance extruders. After I was done with all sorts of troubleshooting I wired up the Makerbot extruders and they worked perfectly. Please Help!!! :) :) :) :)

Re: Replacing Makerbot Rep 2x Extruders with Geeetech dual e

Posted: Mon Feb 29, 2016 11:11 pm
by Mark
Are the heating elements and thermistors fit your own printer?

Re: Replacing Makerbot Rep 2x Extruders with Geeetech dual e

Posted: Mon Feb 29, 2016 11:19 pm
by Mauzman
Yes, the heating elements and thermistors fit the Makerbot Replicator 2x. I have been doing some research and I think I have found the solution. My Makerbot 2x requires Thermocouplers instead of Thermistors. I have ordered 2 new thermocouples and will install them as soon as they arrive
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited