Geeetech

Posted: **Thu Mar 17, 2016 10:20 pm**

Just finish building and setting my G2S.
On my first test of printing, I see the wire going back ie pulled and not pushed.
Any hint? Is it a cabling issue or a parameters (configuration.h) issue?
Thanks

Posted: **Fri Mar 18, 2016 3:42 pm**

need to change the motor direction, check out this link:
http://www.geeetech.com/forum/viewtopic ... 17&t=17037

Posted: **Fri Mar 18, 2016 5:12 pm**

Thanks Mark,
I post a little to fast, I found the solution by myself.
Everything working fine now.

Geeetech

G2S :feeder motor going reverse

G2S :feeder motor going reverse

Re: G2S :feeder motor going reverse

Re: G2S :feeder motor going reverse