Geeetech

Posted: **Tue May 31, 2016 8:16 am**

I found when building my Pro B that the documentation says to use the 390mm smooth rods for the Y axis and 410mm rods for the X axis.

These should be the other way around. If they are not swapped the Y axis only has 180mm of travel.

Other than that the build was quite easy and I am very pleased with the results of the prints.

Posted: **Tue May 31, 2016 9:18 am**

Thanks for your feedback, we'll test it.

Posted: **Wed Oct 19, 2016 2:09 pm**

Is this the case? if so it will answer my post I'm waiting to be approved

Geeetech

I3 Pro B X and Y rods

I3 Pro B X and Y rods

Re: I3 Pro B X and Y rods

Re: I3 Pro B X and Y rods