Page 1 of 1
Prusa i3x extruder does not stop heating
Posted: Wed Jun 01, 2016 10:14 pm
by danygb98
I bought a prusa i3x and i'm having problems with the extruder as it heats more than the selected temperature until ir reaches maximum temperature at about 300 degrees.
What can I do to solve it?
I think it is a problem with the board.
Re: Prusa i3x extruder does not stop heating
Posted: Thu Jun 02, 2016 9:39 am
by Toy
I think you need to check your board according to the post:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
Re: Prusa i3x extruder does not stop heating
Posted: Fri Jun 03, 2016 10:30 am
by danygb98
I Found that when I click to heat only the heatbed on repetier, both, the extruder and heatbed start to heat, I don´t know if that is supposed to happen?
Re: Prusa i3x extruder does not stop heating
Posted: Tue Jun 07, 2016 3:01 pm
by William
Have you checked your motherboard?Is there anything wrong？