Geeetech

Hello

I would like to connect MeCreator 2 with the software Cura 2.3.0.
Cura 2.3.0 does not see printer and writes: Need connect to a printer.

Additional information:
Other software such like Repietier-Host or MatterControl combine with printer perfectly.

Does Cura with MeCreator 2 function generally?
Does somebody have an idea?

Thanks

lalex wrote:Hello

I would like to connect MeCreator 2 with the software Cura 2.3.0.
Cura 2.3.0 does not see printer and writes: Need connect to a printer.

Additional information:
Other software such like Repietier-Host or MatterControl combine with printer perfectly.

Does Cura with MeCreator 2 function generally?
Does somebody have an idea?

Thanks

Yes,Cura is supported.
Did you disconnect the printer with other software before you connect it to Cura and select the right COM port in Cura?Also you can plug your another USB port to see how it goes.

In Cura 2.3.0 there is no choice of com-port for the printer and the printer doesn't work.
In Cura 15.04.6 (the old version) there is a choice of com-port for the printer and the printer works with this version if to expose port in the manual.

I am interested in the Cura 2.3.0 version
Someone has specific proposals according to the solution of this problem?

Thanks

i cannot find com port in cura 2.3