Rostock 301, current limit setting for extrusion motors
Posted: Sat Oct 01, 2016 8:26 am
I saw limit for stepper is Vref = 0.6.
I had to push them to 0.7 to stop loosing steps. It is now ok.
What about extrusion motors ?
because of the difficukty to push pla in diamond hotend, they often loose steps, even at 0.7. Where can i go ?
O,8 is possible ?
Thank you for your help.
Serge
I had to push them to 0.7 to stop loosing steps. It is now ok.
What about extrusion motors ?
because of the difficukty to push pla in diamond hotend, they often loose steps, even at 0.7. Where can i go ?
O,8 is possible ?
Thank you for your help.
Serge