issues
Posted: Sun Jan 08, 2017 1:03 am
Sorry for my bad English.
I have Geeetech unassembled Prusa I3 X 3D printer bought.
The website features the Building Instructions of Geeetech Prusa I3 X.rar
In this manual is a link to an installation video. However, this is different from the assembly manual.
Which is good?
There are also several places different firmware updates, what should I use now.
I also bought the 3DTouch auto leveling sensor.
I'm a day spent without result.
Followed the instructions in the manual
When I boot up the printer using the extruder above the printbed, the light continues to flash
When I boot up the printer using the extruder in addition to printbed, then it works.
The printer starts calibration on 5 points
but starts printing with the extruder about 5 mm above the printbed..
How do I correctly calibrate the sensor?
I have Geeetech unassembled Prusa I3 X 3D printer bought.
The website features the Building Instructions of Geeetech Prusa I3 X.rar
In this manual is a link to an installation video. However, this is different from the assembly manual.
Which is good?
There are also several places different firmware updates, what should I use now.
I also bought the 3DTouch auto leveling sensor.
I'm a day spent without result.
Followed the instructions in the manual
When I boot up the printer using the extruder above the printbed, the light continues to flash
When I boot up the printer using the extruder in addition to printbed, then it works.
The printer starts calibration on 5 points
but starts printing with the extruder about 5 mm above the printbed..
How do I correctly calibrate the sensor?