Hot end not maintaining temperature?
Posted: Mon Jan 16, 2017 1:22 am
I posted a problem about my converted G2s stepper motor but now I'm thinking there may be another issue involved. To repeat my situation: "I just converted my M301 into a G2s Pro by obtaining the dual hot end, probe, cables and GT2560 controller but otherwise kept the parts from my M301, including the extruders and steppers." Aside from a stepper issue, the extrusion slows down after a layer or two.
As I think about it, it has the appearance of not being heated sufficiently to melt it completely. (I'll take a video next time I try) However, the display indicates no drop in temperature. Has anyone heard of a software issue on the G2s that could result in the temperature not updating, allowing the hot end to cool down?
As I think about it, it has the appearance of not being heated sufficiently to melt it completely. (I'll take a video next time I try) However, the display indicates no drop in temperature. Has anyone heard of a software issue on the G2s that could result in the temperature not updating, allowing the hot end to cool down?