Page 1 of 1
Problems Prusa i3 Pro B
Posted: Tue Jan 17, 2017 1:25 am
by Catdog1860
Hello today i habe build my Geetech Prusa i3 Pro B.
All is fin but if i like to print an cube from thingivers th prints are moved on the y-axis by changing the layer.
I use S3D for printing the stl file.
Any idea?
Best Regards
Catdog1860
Re: Problems Prusa i3 Pro B
Posted: Wed Jan 18, 2017 3:01 pm
by Cup
Your Y axis has a layer shifting.
Check if the motor on Y axis was losing steps or the bearing on Y smooth rods is hard to move(spread some lubricating oil on them).
Additionally,check the belt on Y axis is too loose or too tight.
Re: Problems Prusa i3 Pro B
Posted: Wed Jan 18, 2017 3:30 pm
by Catdog1860
Hello Cup,
thank you for your answer.
Yes the Belt was to loose.
I have fix it and now i can start to print.
Re: Problems Prusa i3 Pro B
Posted: Wed Jan 18, 2017 3:33 pm
by Cup
Congratulations.
Re: Problems Prusa i3 Pro B
Posted: Thu Jan 26, 2017 5:24 pm
by phil135
i have some x y shifts too
how can simply i check the belt tension ?