Geeetech

Hello All!

First I like to thank you all for this forum and your support which was very helpful in the last few days when I was reading your posts.

My Mecreator doesn't prints very small features. I think it's because of the 0.4 nozzle? If yes, which nozzles are compatible and how to change the nozzle?

Cheers
Florian

Florian-HH wrote:Hello All!

First I like to thank you all for this forum and your support which was very helpful in the last few days when I was reading your posts.

My Mecreator doesn't prints very small features. I think it's because of the 0.4 nozzle? If yes, which nozzles are compatible and how to change the nozzle?

Cheers
Florian

Hi,the nozzle's diameter is 0.4mm.You can find it in here:https://www.geeetech.com/index.php?main ... le&x=5&y=7

Thanks for your answer.

You meant that I could change it to this one https://www.geeetech.com/brass-m6-nozzl ... ala44lg073 ?

My idea was that perhaps my nozzle's diameter is too big therefore I would try a 0.3mm diameter.

Florian-HH wrote:Thanks for your answer.

You meant that I could change it to this one https://www.geeetech.com/brass-m6-nozzl ... ala44lg073 ?

My idea was that perhaps my nozzle's diameter is too big therefore I would try a 0.3mm diameter.

Yes,you can try.