Z-axis wireing in the duplicator 5
Posted: Thu Oct 12, 2017 4:03 am
https://www.thingiverse.com/groups/geee ... opic:21748
Well this is a major screw-up , the wireing harness that goes to the Z-axis end stop is 10 cm to short .
I have lots of breadboard jumpers so i just used 3 x 10cm ones I had on hand but not everyone has these .
The build platform can get jamed , or just unplug the endstop .
I hnow it is a easy fix , and for 299.00 USD this printer is still very good bang for your buck .
This problem is a strange one and , as this is a DIY kit , most if not all people who buy this assemble it them selfs .
As a DIYkit the instructions on youtube are excellent .
It could be a one off problem with the wiring harness as this printer uses a custom wireing harness but daam what a pissoff .
Well this is a major screw-up , the wireing harness that goes to the Z-axis end stop is 10 cm to short .
I have lots of breadboard jumpers so i just used 3 x 10cm ones I had on hand but not everyone has these .
The build platform can get jamed , or just unplug the endstop .
I hnow it is a easy fix , and for 299.00 USD this printer is still very good bang for your buck .
This problem is a strange one and , as this is a DIY kit , most if not all people who buy this assemble it them selfs .
As a DIYkit the instructions on youtube are excellent .
It could be a one off problem with the wiring harness as this printer uses a custom wireing harness but daam what a pissoff .