GTM32 pro Connection
Posted: Sat Oct 21, 2017 7:39 pm
Hi
I am new to this hobby,
I just bought a Geeetech Prusa I3 M201 printer as a kit. The control Board included in the kit is "GNT32 pro Vb +5 A4988". Following the building instructions i came to a problem.
The instruction does NOT indicate how or where to connect the Hotend (Nozzle) 4 Red cables (to of them joined to a 2 pin connector) and also where to connect the Hotend fan to de GTM32 pro board.
I have searched the web looking for any information but I couldn't find any.
Any advice would be very much appreciated.
Tank you for your help
Best regards.
skywalker.
I am new to this hobby,
I just bought a Geeetech Prusa I3 M201 printer as a kit. The control Board included in the kit is "GNT32 pro Vb +5 A4988". Following the building instructions i came to a problem.
The instruction does NOT indicate how or where to connect the Hotend (Nozzle) 4 Red cables (to of them joined to a 2 pin connector) and also where to connect the Hotend fan to de GTM32 pro board.
I have searched the web looking for any information but I couldn't find any.
Any advice would be very much appreciated.
Tank you for your help
Best regards.
skywalker.