Page 1 of 1
extruder problem for ABS print
Posted: Sun Jan 07, 2018 3:48 am
by krcma
Through ebay i ordered a printerGeeetech aluminium Prusa mk2 i3. The extruder does not want to print ABS material. What am I wrong with? Tnx for help.
Re: extruder problem for ABS print
Posted: Mon Jan 08, 2018 4:29 pm
by William
Could you give us more details about the issue?
Re: extruder problem for ABS print
Posted: Fri Jan 12, 2018 6:57 am
by krcma
Hello.
I have more problems with my Geeetech alu prsa 3d printer.
I do not know how to change the direction of the engine on the Z-rod. I do not know how to teach firmer Marlin-Arduino as described in the forum. I managed to turn the wire switches so now the engines go in the right direction.
Printer prints PLA PRO wire, edges are very rough. The ABS wire comes out for 5 seconds and then goes out of the nozzle.
tnx for help
Re: extruder problem for ABS print
Posted: Fri Jan 12, 2018 4:33 pm
by William
The temperature of ABS is 230-270 and the bed is 95C
If you don't know how to change the direction of the motor, you can upload the configuration.h file to google drive.
I will help you in my spare time.