Geeetech

Hi all
I am new to the world of 3d printing. I want to fabricate a 3d printer. I purchased GT 2560 3d controller box ( P13 A pro) and installed Repetier- Host V2.0.5 software,serial port drivers . Then connected the controller to pc with USB cable. Its showing as connected. Is this enough to run the 3d printer. Or do i need to install marlin too?( i am not familiar with marlin.)
Thanks

Could you upload the video to Youtube and then attach the link to the post?

Dear Willam
Thanx for your feed back.
https://www.youtube.com/watch?v=2Ti5YZobCsY

Please refer the above link.Do we have any user manual for this controller? i found one but it is not a complete one.

You can refer to this pdf file
https://drive.google.com/open?id=1LlcOl ... 0fSphLt0Q-
Seems you haven't built the heated bed and nozzle heating cable and Endstop cable.

Actually we are fabricating the whole 3d printer. we bought the P13A pro controller. My doubt is, whether i can use printrun or repietier-host software to run the printer? or Marlin is a must one?
I hope i can calibrate the axis via M92 command in printrun. Am i correct?

GT2560 basic on Marlin firmware.You can send M92 for calibration

Thankyou