Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

No Filament transport with MK8 Extruder

http://forum.geeetech.com/viewtopic.php?t=61072

Page 1 of 1

No Filament transport with MK8 Extruder

Posted: Mon Apr 16, 2018 7:27 pm
by BR365
Hello,
we assembled the Geeetech I3 Pro C Dual sucessfully, but the filament transport seems to not working. When printing from the PC software, there is only one little drop of filament on the nozzle.

Is it neccesary to set up the E-Steps for the filament transport?

Regards,
Moritz

Re: No Filament transport with MK8 Extruder

Posted: Wed Apr 18, 2018 2:07 pm
by BR365
I found the problem: The connector for the stepper motor of Extruder 1 and 2 were interchanged. Now, it works fine.
All times are UTC+08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited