Page 1 of 1
Deformed (ovalized) prints (RESOLVED)
Posted: Sun May 27, 2018 11:00 pm
by ALE5510
So, trying to print the objects to test the printer a little, but the result of the circles is this is not at all nice. They are deformed (ovalized), and even the square objects are slightly elongated
[attachment=0]WIN_20180527_16_54_13_Pro.jpg[/attachment]
unfortunately I can not understand something is due :-(
Re: Deformed (ovalized) prints
Posted: Mon May 28, 2018 12:28 pm
by _kaktus_
Have you already tried to calibrate your printer?
In the forum it is described how to do it.
Re: Deformed (ovalized) prints
Posted: Mon May 28, 2018 2:40 pm
by ALE5510
I have to try using MotorController. They also advised me to use Repetier (I can not use it but I'll learn ...).
The printer is new (mold for a week), but yesterday looking at the arm Z X seemed slightly wrong. Tonight I will take some pictures.
Re: Deformed (ovalized) prints
Posted: Wed May 30, 2018 10:47 pm
by ALE5510
I solved the plate and tightening the axis belt =)
Re: Deformed (ovalized) prints (RESOLVED)
Posted: Thu May 31, 2018 5:21 pm
by Gingko
Cool,
you solved it just by tightening the belt?
Look forward to your experience sharing!
Re: Deformed (ovalized) prints (RESOLVED)
Posted: Sat Jun 16, 2018 7:04 pm
by ALE5510
Yes!
I disassembled the plate by unscrewing the two screws in front of and behind it. at the back of the printer there is a tie-rod (a screw) of the belt, I loosened it, I pulled the belt and I tightened the screw well. when reassembling the plate, make sure that the black pin underneath the plate remains in the upper left corner of the printer, where there is the limit switch sensor.