Printer Protocol Setup.
Posted: Wed Aug 15, 2018 8:03 pm
Hi
I have a question about general printers.
When configuring a new printer in each Slicer application, you must specify the type of printer you want to use each time.
For Geeetech equipment, which selection criterion to use.
Could anyone say anything more about that
I attach two configuration views.
I have a question about general printers.
When configuring a new printer in each Slicer application, you must specify the type of printer you want to use each time.
For Geeetech equipment, which selection criterion to use.
Could anyone say anything more about that
I attach two configuration views.
- RepetierHost.png (19.77 KiB) Viewed 3998 times
- CuraUltimaker.png (162.07 KiB) Viewed 3998 times