PI3A Pro 3D control box Firmware upload Error codes
Posted: Sun Sep 02, 2018 12:28 am
Hi learned folks - I'm new to 3D printing and struggling to flash the firmware with a mod to change the Y axis direction.
Using Arduino 1.0.1 as instructed, loading up the correct firmware (as per the Geeetech site) for my version - with the lead screw mod and the 3 D control box.
Firmware loads up in to the Arduino IDE, got the correct com port set and Arduino board (2560/Mega) as instructed.
Try and upload and I get this error stream;
uint8_t u8g_dev_rrd_st7920_128x64_fn(u8g_t *u8g, u8g_dev_t *dev, uint8_t msg, void *arg)
Any help much appreciated
T
Using Arduino 1.0.1 as instructed, loading up the correct firmware (as per the Geeetech site) for my version - with the lead screw mod and the 3 D control box.
Firmware loads up in to the Arduino IDE, got the correct com port set and Arduino board (2560/Mega) as instructed.
Try and upload and I get this error stream;
uint8_t u8g_dev_rrd_st7920_128x64_fn(u8g_t *u8g, u8g_dev_t *dev, uint8_t msg, void *arg)
Any help much appreciated
T