Page 1 of 1
Motors arent moving and both bed and extractor doesnt heat
Posted: Sun Sep 09, 2018 6:04 am
by SamBlack249
I have just finished building, i followed the guide on the manual and i also have looked at many videos. However none of my motors will move and my bed and extracter won't heat either?? anyone got any ideas. please it would be very helpful.
Re: Motors arent moving and both bed and extractor doesnt heat
Posted: Sun Sep 09, 2018 1:47 pm
by _kaktus_
Hi
In some versions of the controller, the logical part of the circuit can be powered from a USB port. However, this is not enough for the printer to work.
That's why I have a question if you haven't forgotten to switch on the main power supply
If you turned on the power and the problem occurs, check if it works properly.
