Wrong moves after enabling Auto Levelling
Posted: Fri Oct 12, 2018 4:37 pm
Hi, i am very confused...
After installing CAP sensor and enabling Auto levelling there are some strange behaviours.
I have A30 with latest firmware and printed some objects with manual levelling fine. Since i activated auto levelling these things are going wrong:
- manual filament retracting will not retract filament, but moves plate in y-axis to front without stopping (no response when pressing stop on touch, have to power off)
- during printing, sometimes filament was retracted and head moves z-axis to top without stopping.
I can see, that auto levelling is processed before every job started. In built end switch for z-axis (on the bottom) will never be reached, because of cap sensor is used for finding home position.
When i disable auto levelling, everything works fine again. What can i do?
thx in advance
Terry
After installing CAP sensor and enabling Auto levelling there are some strange behaviours.
I have A30 with latest firmware and printed some objects with manual levelling fine. Since i activated auto levelling these things are going wrong:
- manual filament retracting will not retract filament, but moves plate in y-axis to front without stopping (no response when pressing stop on touch, have to power off)
- during printing, sometimes filament was retracted and head moves z-axis to top without stopping.
I can see, that auto levelling is processed before every job started. In built end switch for z-axis (on the bottom) will never be reached, because of cap sensor is used for finding home position.
When i disable auto levelling, everything works fine again. What can i do?
thx in advance
Terry