Configuration.h file for Marlin 1.1.9
Posted: Tue Oct 23, 2018 3:57 pm
Hi,
I have a standard from the factory i3 pro b, with no modifications ( so standard threaded rods etc )
I updated my 3d printer to Marlin 1.1.9 using the example configuration.h from the geeetech i3 pro b example configurations folder.
I'm not sure if this is correct.
Is there a 100% correct Configuration.h file on this forum? I have looked through the post viewtopic.php?f=20&t=17046 but at 33 pages long, its difficult to find the right firmware.
I have a standard from the factory i3 pro b, with no modifications ( so standard threaded rods etc )
I updated my 3d printer to Marlin 1.1.9 using the example configuration.h from the geeetech i3 pro b example configurations folder.
I'm not sure if this is correct.
Is there a 100% correct Configuration.h file on this forum? I have looked through the post viewtopic.php?f=20&t=17046 but at 33 pages long, its difficult to find the right firmware.