Page 1 of 1
Heat bed suddenly stopped working on first print.?
Posted: Sun Dec 30, 2018 6:22 am
by crispin137
Heat bed stopped working on first print. Haven't got my multi meter with me yet . But any suggestions would be appreciated. Have managed to print half a bowl of spaghetti so far
Re: Heat bed suddenly stopped working on first print.?
Posted: Mon Dec 31, 2018 8:27 am
by steveski21
Have you check the Heatbed plug where it goes into the control box
My heatbed stopped working the other day and one of the pins in the plug was tight enough and had turned blue from the high resistance