Geeetech

Ok. I have a very, very, Very dumb question. Aside from the obvious size, what is the difference between 1.75mm and 3.0mm filament? Quality? Larger prints?

Hi.


In my opinion, with a thicker filament you can get a thicker layer.
Then the extruder is more efficient. But this requires a more powerful heater.


My friend remember, there are no stupid questions, there are only silly answers.

Agree with kaktus's points.
You can refer it,if you can test it you will more clear about it.

I'm guessing I would have to change the hot end and the nozzle to a 3.0?