Extruder mount
Posted: Fri May 31, 2019 8:12 pm
So when I go to mount the extruders the holes pre drilled leave the bracket setting on a mount screw. Am I doing something wrong?
Look how I did it.
This assembly resulted from my observations and reflections.
.
- ekstruder_M201.jpg (249.26 KiB) Viewed 4365 times
Bowden tubes lay more freely when printing. There are no such big bends. Each bend in the tube leads to a narrowing of its diameter. This in turn leads to a greater difficulty for the filament that moves inside of it.
˙ǝɯᴉʇ ǝɥʇ llɐ ɹoʇᴉuoɯ ʎɯ ǝʇɐʇoɹ oʇ ʇuɐʍ ʇ,uop I ˙soʇoɥd ɹnoʎ ɥsᴉlqnd noʎ ɥɔᴉɥʍ uᴉ uoᴉʇɐʇuǝᴉɹo ǝɥʇ oʇ uoᴉʇuǝʇʇɐ ʎɐԀ ˙noʎ oʇ ǝʞɐɯ oʇ ʇsǝnbǝɹ ɐ ǝʌɐɥ oslɐ I
